FAQ
Search By Categories
Most Asked Questions
- “Vdd Overload” message
- Do I need the RS-232 communication?
- What is the expected service life of the programmer in terms of operating hours, days, or years?
- How can a Unique ID be read when operating in standalone mode?
- Can the ICP2(G3) keep the T_VDD output enabled after programming is completed? We need it to continuously supply VDD.
- No communication with ICP2-GANG(G3) from ICP for Windows
- PASS or FAIL 5VDC signal stays on until the next test. Is there a way to reset the device other than a 120VAC power cycle to where neither the PASS or FAIL light is on going into the next test?
- How can I activate my MCU for programming?
- What does the Secure Programming do?
- What is the battery life of the ICP2-Portable(G3)?
- What is a RAM buffer?
- How can I see the activated families?
- I’m using an ICP2(G3) to do a single word write/read to the EEPROM of an ATTiny817 at address 0x1413 and I’m having issues
- How can I set the security bit on the ATSAMD20E15B? The main purpose is to lock the chip memory to prevent any further access to internal data through external programming and debugging interfaces. Once the security bit is set, how can I clear it?
- How can I get PJ2 checksums without a connected programmer, for example directly from a PJ2 file?
