Hardware
Browse questions within this category. Use hashtags to quickly filter by topic and find the most relevant answers.
Search By Other Categories
Questions
- “Vdd Overload” message
- Can ICP family programmers be powered from the USB line?
- Do ICP programmers support high-level operation?
- How should I connect my target device to the ICP programmer?
- I need a long cable between ICP programmer and the target MCU. What should I do?
- I need to connect a brown-out reset circuit to the MCLR/RESET pin of a microcontroller. How should I connect it to allow in-circuit programming?
- Mating connector for ICP2(G3), ICP2-GANG(G3), ICP2-Portable(G3), ICP2-ISO(G3) and ICP2-LAN(G3)
- Reset IC STM1001 on VPP/MCLR
- Target cable with twisted pairs
- What is the battery life of the ICP2-Portable(G3)?
- What is the expected service life of the programmer in terms of operating hours, days, or years?
- What is the maximum cable length?
- Why do I need a programmable delay between Vdd and Vpp (Vdd-to-Vpp)?
- Why do I need galvanic isolation?
